How to watch live streams on BlueIris

                          Before set up

                          1. Your camera and your PC are on the same LAN

                          2. The BlueIris software has been downloaded and installed on your PC

                          3. You are familiar with BlueIris software

                          Start set up

                          Step 1: Loading BlueIris.

                          Step 2: Click + on the top-right corner to add a new camera.

                          Step 3: In the popup New camera window name your camera. If you prefer to have audio together with

                the live video, have Enable Audio checked. Then click OK

图片1

                          Step 4: In the popup Network IP camera configuration click the Find/inspect... button. Your camera

                          should be automatically detected.To find out your camera ip pls check: FAQ8-How to setting the fixed IP

图片2


                          Step 5: Select the corresponding camera and then click OK

                          In some cases your Wi-Fi router may have configuration that hinders automatic detection.

                          Should it happen type in "http://your camera IP address:5000/onvif/device_service" to manually add the camera.

图片3

                          The BlueIris starts to connect to the camera for retrieving configuration parameters.

                          You can see the progress in the Inspecting... window. The "Done" displayed in the scroll window signifies a successful retrieval.

                          Click Close button.

图片4

                          Step 6: Now you are guided back to the Network IP camera configuration window with many parameters filled. 

                          If User and Password are filled, remove them to leave these two parameters blank.

                          Click OK to establish the connection.

图片5

                           If the BuleIris doesn't find the camera automatically (this offen happens when router fails for the auto

                          discovery procedure), you can fill the parameter manually following the diagram above.

                          The key parameter are listed as below,

3

                                                                                           

                          Then click OK button.You will see the configration menu below, just click OK button.

图片6

                          Note: It may take some time (usually less than one minute) to build the connection. In the duration

                            before the connection sets up, the vertical color lines are displayed. If you have waited more than one

                            minute, stop the connection and return back to check the connection parameters in the Network IP

                            camera configuration window



Sales
Support
Scan

Scan
More company information

Unified service hotline
0755-29360806

TO TOP